The Micplexer is an antenna distribution amplifier for diversity wireless microphone systems. The micplexer connects to 2 antennas and distributes the signals to up to 4 wireless microphone receivers. Each of the 2 RF channels has 8 dB of RF gain. The channel gain can increase the usable distance of the wireless microphone receiver depending on the ambient RF noise floor at the location the micplexer is used.
Each of the 2 RF distribution channels in the micplexer are bandwidth limited to a 40 MHz range. The Micplexer must be ordered in a specific frequency block from 500MHz to 850 MHz, it can only be operated within the block it is built for.
MicPlexer is the same size as a standalone Zaxcom receiver. It can be used stand alone or within a ZaxPaq and with combination of Zaxcom wireless receivers (QRX100 or RX900s). It can feed 3 Zaxcom receivers contained within the frame and 1 external receiver or other antenna distribution systems. Micplexer is powered from externally with 8V to 18 VDC, a 12V power conditioner and distributor are also included.
The micplexer offers a very high IP3 figure of +20 dBm. This eliminates amplifier overload and intermodulation generation in the micplexers RF amplifier. Micplexer noise figure is a very low.
The ZaxPaq is a metal housing with four slots, it conveiently holds three QRX100 receivers and one MixPlexer to form a modular RF microphone system. The ZaxPaq is portable and can be used in a sound bag or cart.
MicPlexer Cable Set
The MicPlexer cable set consists of 6 x RF cables and 2 x power cables.
RX Gain: 9 dB
RX Configuration: 1 in 4 out x 2
RF Connectors: SMA Female
RF Input Ports: 2 (Front Panel)
RF Output Ports: 6 (Rear Panel) / 2 (Front Panel)
Dimensions (H x W x D): 1.25″ x 3.25″ x 5.25″ (32mm x 83mm x 133mm)
Power Consumption: 1 Watt
Input Voltage: 8 -18 VDC
DC Output Port: 3 (1/2 Amp Max Per Port, Internally Fused)
DC Power Connector: Switchcraft L712
All Specifications subject to change without notice